Protectol C

R132,25

incl VAT (bulk discounts apply) (bulk discounts apply)

A flexible seal and coating surface protector to shield and protect your equipment. Protectol will also prevent moisture, oils etc from forming on electrical and industrial equipment. Also prevents arcing.

Product Code:

c1-protectolc-400

Applications

USES

Used on all electrical windings, inside of motor frames, commutator parts, separator coils etc.
An arc resisting coating for controller shafts, switch bases and other electrical insulation.
Seals oil lines, airlines, gaskets, threaded pipes, crankcase flanges and battery terminals.
Prevents corrosion on aluminium and all other metal surfaces.
A HVAC coil protective coating

METHOD OF USE

All surfaces to be coated should be free of moisture, oil and grease.
Preparation is critical to ensure maximum adhesion. A Cyberchem recommended chemical must be used and in the correct dosage.
The coil must then be properly rinsed to remove all residual chemical before coating is applied.
Coils must then be thoroughly dried before application.
When using an airline sprayer, hold nozzle approx. 20 to 30 cm from surface to be sprayed.
While spraying move nozzle back and forth quickly to deposit an even finish. May also be applied with a paint brush.
Leave to dry for at least 30 minutes.
Coverage: 12 – 16 sq/m per Litre

IMPORTANT

Clean surfaces with an alkaline degreaser (MX-40) or equivalent coil cleaner (Recoil). The manufacturer will not be held responsible, if this degreasing practice is not adhered to.

Specifications

CHEMICAL PROPERTIES

A blend of resin and solvents
Specific Gravity	0.850

Product Specifications Documents

PDI Protectol Spray.pdf (90.66 KB)

Precautions

SAFETY PRECAUTIONS

Eyes	Rinse eye with water & seek medical attention
Ingestion	Do not induce vomiting. Wash mouth with water. Get medical attention
Inhalation	Remove immediately to fresh air
Skin	Wash with soap and water